creia's latest activity
-
creia replied to the thread Having carb issues with HS 50 mini bike I just bought..That certainly has not been my experience. I have used Sta-Bil Fuel Stabilizer in all of my small engines, including motorcycles, for... -
creia replied to the thread Having carb issues with HS 50 mini bike I just bought..My experiences with the "aftermarket" (China-made) Tecumseh carbs has been a hit and miss. I would say that about 50% of the time they...
-
creia replied to the thread Not a m.b. but a three wheeler.Bad link. Michael
-
creia replied to the thread Not a m.b. but a three wheeler.Bad link. Michael
-
You gotta love it. New guy that knows absolutely nothing comes on here with a very open ended vague question. 7 or 8 long time, very...
-
creia replied to the thread New to mini bikes, I have some questions..Pancho, The feelings you have "vented" are shared by MANY on this forum, myself included. I have been hanging around here since 2011 and...
-
creia replied to the thread Predator 212 Upgraded and No Start.If you were losing air at the head gasket have you considered flattening/leveling the block deck and the head? (they might not have been...
-
creia replied to the thread Predator 212 Upgraded and No Start.Did it EVER start and run? That is to say, BEFORE you did your "modifications" to it? Michael
-
creia replied to the thread B&S armature/mag.Assuming you saw this one listed on eBay? If you have not, make sure you are sitting down when you see the price!! LOL...
-
creia replied to the thread Briggs and Stratton 8hp Crankshaft Cross Reference..Curious as so what $$ amount do you consider being "very expensive"? Michael
-
creia replied to the thread Fixing scratched Briggs piston?.Forget about that scratch pad, honing or oversize rings. Both the bore and that piston are SHOT. Michael
-
creia replied to the thread Small engine swap for my cruiser.The old "rubber washers under the engine" technique has been discussed and tried before on this forum, however, it has been at least a...
-
creia replied to the thread Tecumseh Hssk50 wont fire.Did you ever get spark? If you do have spark, even at 65PSI (which IS pretty low) it should still at least fire and (barely) run, but it...
-
creia replied to the thread HSSK50-What needs to be done?.The crankshaft end looks a little funky. Remove the bolt and washer and give us some better/more pics of the crank end. Does it have a...