I have a new powersport on the shelf in my shop , send me a pm and will give you my cell number text it and i can send you pics of carb and govenor linkage
Did You have to cut one seat into the other and if You dont mind me asking how close does the intake valve to the cylinder wall , Again very impressive modification I hope You post more pics once the rockers are set up !
Junior have you yourself tried the black mamba cam ? I installed one ona gx200 that was in a baja with a TAV and it ran fine with no stall speed issues at all , and no upgrades were done to the stock carb . except for adjustments to idle and fuel mixture . You will not find a better package for...
Its a private forum , You dont have any 1st Amendment rights ( frredom of speech ) Admins and mods have the control to edit and ban , If a forum is public than anything can be said without censorship !
1st ck the valve cover and is sure the breather is working sometimes if your valve cover breather is stuck it will push oil out of seals and gaskets !
awhile ago my buddy had a gx390 on his minicup kart that would leak oil out the side cover gasket , he changend the gasket 3 times still...
Ck out Iskys Black Mamba $75.00 special You get a 270 lift 246 duration cam 28lb springs valve cover and side cover gasket with an autolite racing plug , great package I threw one in a gx200 sweet little cam for a mild mod !
.050 off the head would leave at 9-1 with a g160 head gasket which will run pretty good with a bsp cam and 18lb springs .and with that setup you can be in the 10-1 range if you use a gx200 gasket and thats without decking the block or using a longer rod . personally i wouldnt run much over 10-1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.