Recent content by lonesherpa

Got any triple trees to match?:shrug:

Nice :thumbsup:

Hydraulic Brakes from Great Plains Aircraft! Here is the same bolt on disc brake kit for azusa wheels, but this site also sells the parts individually. I'm just in for the hats and disks, much cheaper. :smile:

Wicks Aircraft Supply a bit much but looks like it brakes well:laugh:

Probably in the same category as a "megaphone" :smile:

Probably an old school minibike security system :smile:

Antique Gas Engine Parts Suppliers This is a quote from the site above: "All types of ENGINE PARTS for: Fairbanks Morse, Ajax, Continental and Arrow. One of the largest ZC52 inventories in captivity: Jimmy F. Bell Equipment"

Looks like fun until you twist the crap out of your ankle

Yeah BMI has a nice section. http://www.bmikarts.com/shop/?cart=1794176&cat=218

I think TAS motors turned into Tanaka....I think... Walbro 15mm HP Carb wa-15-2 - ADA Racing Get a generic 50cc 2 stroke carb and tape it on or something :thumbsup: good luck! First thing you learn about minibikes is that parts are hard to find

Similar story with my fox, the previous owner had replaced the worn out stock parts with whatever crap in their yard. It had a lawn mower caliper biting the sprocket, on one side. Not to mention some trick wood hardener soaked cardboard for fenders :out: Im not sure if fox made them all...

I don't think I've seen a front suspension setup before. (Somewhere a small block is missing a valve spring) Is it clunky at all? It looks like the top yoke would slam into the head after a bump.

Hmmm now what about rear sprockets and wheels?

You're right A setup like this (where the lower tree puts the forks further from the steering head) would give the bike a less dangerous and more comfortable geometry

Someone needs to put this in their mini, and take it to the bonneville salt flats. "No officer there is no way I was going 110 its only 49cc, see how little it is" :wink: