Recent content by naterater

i would expect to need longer rods , when you get it set up youll know just by looking

two words : slide carb

#1 rotella? no. you need to be running a much heavier oil . in my pred , i use none other than full synthetic 15w-50 made by napa . i can run my bike everyday for two weeks to a month before i need to change the oil. and your not going to warranty anything from harbour frieght that you modified...

and what happens when your riding and your engine instantly loses compression cause the exaust valve got bent and the keepers slipped and jammed the keepers into the retainers {billit} but the valve didnt strike anything it just wasnt properly closing. removal of the keepers showed the groove on...

id be embarassed to post mine as a tazmainian devil has apparently taken refuge there. or a tornado hit it . either way i got too much stuff but my ocd wont let me sell it .lol tight pad too btw looks like youll have plenty of room buy cameras to protect your toys . happens in the country and...

take off the carb no doubt its gunked up . find a container big enough to put the carb in . put it in , fill with b12 chemtool let sit over night. next day take it out drain it , put it back on , bet it works now. i do this alot more for 2 cycle carbs but will work on both and wont rot the...

well i just figured it out. it appears that the clutch i just bought is to blame . the sprocket on the clutch has a lip on it and when the masterlink on the chain tries to go thru the clip on the link hits the lip on the sprocket and its enough to offset the chain . so in the morning im takin...

my bad heres what im using : harbor frieght predator 212 , billit rod ,flywheel , 26 lb springs , black mamba cam,22 mm mikuni carb, mikuni intake . 12 t clutch >15t jackshaft :13t jackshaft> 60t sprocket.

i used to have a problem like this on my cart when i was young and i can remember it seemed to stop,but has returned to my bike this time.for some reason it keeps breaking the chain , i am concerned because its gold on gold rlv chain and we know what kind of stress that can take. its just the...

still got it? how much? rtc 6 or rtb ? is it built or stripped down? lmk

your playing with fire, i had a 60$ header with a micro hole in the weld burn the pipe out, and the hole it made in the pipe, is where the torchlike fire shot out and hit my leg for a sec before i noticed i was on fire. its just not worth the money you save at OldMiniBikes when the emergency room visit...

the california model has the epa carb and exaust , take off throw away. get the governor out , billit rod and flywheel , you wont notice any difference. i have both models . currently using the ca block with the rtb-02 head , it has bigger valves than the rtc 6 , the rtb-02 comes stock with...

so whens someone gonna get a 69730 and 60363 with comparable like builds and dyno?

at first when i saw the pic of that air filter , 1st thought was huh mine are pretty clean 2nd thought was how many packs of cigarettes did that bike smoke? looks like the carb might have cancer xD

i use a 22mm mikuni carb on my pred , and they can be a pain in the arse. i have considered getting a tillotson, but im not rich. one thing i noticed if i used a cheap curved manifold for the carb , the intake gasket doesnt fit properly and causes gas to back up in the manifold and acummulate...