I was thinking the same thing about it being such a short lap. I am still building my bike with this as the end goal. I was thinking of a endurance challenge type event at AOAA Trails in PA coal region.
FYI, there is a NY Gambler 100 mini bike endurance race, you versus your machine. Mini bikes, mowers , run what you have. They have a facebook page. I plan on going if I can get my stuff together!
25 pickup or 35 shipped
12V starter works good. May fit other engines. I have other parts of the same engine available send me and email and ask.
https://drive.google.com/file/d/0B0v4U_rswuqdQ25acnFGLVVXOEU/view?usp=sharing...
Working pull start assemble for Tecumesh. Only issue is chip in handle and a some scratches in the bad over sprayed paint.
$20 shipped to you door.
https://drive.google.com/file/d/0B0v4U_rswuqdOUxtMEJxYXV2TTQ/view?usp=sharing
Short intake for 8-10 HP Tecumseh engine. Includes bolts for both block and intake. $10 Shipped to your door.
https://drive.google.com/file/d/0B0v4U_rswuqdekN0Znh0ZGZjQk0/view?usp=sharing
Fuel Pump works, carb is for parts. Motor ran good, linkage was messed up and the thottle got twisted around bending the plate. Was painted white/red/black at some point. The butterfly throttle plate was bent, so I took it off.
$17 shipped. I will have more 10 Hp parts since I am parting...
I have a GX120 in my Fox. Engine runs great but it has the stock exhaust that exits into my leg. Will an exhaust for a GX160-GX200 work with this engine?
For some reason I cannot upload a picture. I am looking at mini and the looks like lower rear frame horizontal and verticals tubes are crimped then drilled and held together by the axle bolt. Does any one know what this is?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.