Recent content by rebelyell

Bottom dollar.

PRICES LOWERED!!! Now asking $130 for FULL SET+ shipping costs of method of your choice. Shipping weight will be around 35 LBS for the full set of 2 fronts, 2 rears, hardware, and 4 wheel girdles for the rears. Will do fronts or rears separately with hardware. $130 for FULL SET - front + rear...

Dang, what a blast from the past!!! My Grandmother owned a Honda / BMW cycle shop until 1989, so I grew up on these bad boys!!! Well, these and a bunch of bikes/ATV's. If I remember correctly, there was another version??? (2 wheeler??) Thanks for posting!!!

I now have these. Everything is brand new and unused. I loosely assembled a rig for photographic purposes. See link below. wheel tire girdles pictures by lickford - Photobucket Here is a full rig, fronts and rears. 2 - 6" Kenda 4.10/3.50-6 slick tires 2 - 5" Kenda 4.10/3.50-5 slick...

Belt sander. Ghetto, but effective.

SUPER fun lil karts, but finding interchangeable parts is a b****.

Do you have a fresh diaphragm in your carby? Also, use 2 carb-to-tank gaskets and tighten em down SOLID. Make sure your carb-to-block bolts are tight too. Or, just carry a can of ether.

Put an air filter on that thang!!! Are you trying to ruin your motor?!?!?

Is this home-built? If not, do you know what brand it is??

Pro's??? Are there any?

Hope it wasn't a winner!!!

Powder coated tins, y'all. . . . . .

Seems reasonable............:shrug: Helluva score for fifty beans!!

Lube yer dang clutch bushing.

Either the carb-to-block gasket, or the carb-to-tank gasket. I use 2 carb-to-tank gaskets to ensure a good seal.