Recent content by RonH

will do thanks

The smaller one on jackshaft is 8 tooth

45 tooth 40 chain bolt holes are 2 1/2". ID is 1 11/16 Anybody know where I can find one

Ok thanks

Sure will

I'm kinda new at this it's a 30 series but I think I have it figured out. Trying to rebuild a Baja trike and found out today the shaft the driven torque converter is mounted on is bent. Haven't looked under neight it yet but feels like a little gearbox

It's one of the Chinese knock offs

Does it matter which way I install it Spring toward tire side or Spring toward engine side and would I have to reverse anything

Thanks for info I just bought this baja cub trike the center line between the shafts is 7 1/8 the belt is 5/8 in wide I don't know if any of this is original both the clutchs say comet on them

Is this a. Comit 20

Howdy I'm the new kid from Fritch Tx and I just started a project yesterday and don't have a clue about what I'm doing so just bear with me.I'll try to post a picture of what I have any information will sure appreciated Wow the picture was way to big I'll have to figure it out first