Recent content by useng1

SOLD

https://detroit.craigslist.org/mcb/for/d/utica-minibike-heald-vt5/7444077453.html I haven't been on this site since the grandson got his drivers license several years ago. Wanted to let you all know I have this minibike on Craigslist. I hope I have posted properly.

Your sub panel needs its own 8 foot ground rod and maybe two at least 6 feet apart. Top of rods 1-2 feet below ground level. Sub panel box must have a separate ground bar for all the bare ground wires to attach to. Ground bar must be connected to the ground rod/rods via a #6 bare ground wire...

Sent mine.

Great, pic showed up.

Are these what you are looking for. I was told they are Rupp. Don't know what model. I don't know if you can get a pic from this. I went on search and think I followed directions.

PM sent

I need one as well.

Years ago, Certified Parts in Wisconsin(Janesville?) was the parts distributor. They may still be.

The variation should not change with sprocket diameter change so long as the number of teeth stay the same. The chain pitch would change. Now if you are talking about belt drive with no teeth, then diameter changes cause variation in output speed.

We know it will go faster with the 25t front sprocket, so the ratio is 25/24 x65=67.7 mph Man, this stuff is hard. College was 55 years ago, but I think I'm right. Simple % change, 25/24

pm sent

That is about right on price. I had a company lined up a couple of years ago to make 12 springs at $30 each. No one wanted to pay that much.

Who got a good deal today?

Current issue of Hot Rod has a minibike article on page 16.