Recent content by vwfan79

I purchased one thanks guys Sent from my iPhone using Tapatalk

Found one Sent from my iPhone using Tapatalk

Done done and done Sent from my iPhone using Tapatalk

Looking for a nice straight harrison roller or would take a pak mule roller too. Sent from my iPhone using Tapatalk

I know thanks Sent from my iPhone using Tapatalk

I know thanks Sent from my iPhone using Tapatalk

Looking for a straight clean Harrison wildcat or bobcat. No bends or rewelds. Roller or frame and fork set Sent from my iPhone using Tapatalk

Looking for a straight clean Harrison wildcat or bobcat. No bends or rewelds roller or frame and fork set post pics and price please Sent from my iPhone using Tapatalk

Sorry been busy, but the engine sold. Sent from my iPhone using Tapatalk

I have a hemi predator with 32/28.5 welded head 13cc chamber 1.2 gage roller rockers havoc gas ported billet piston +.020 arc rod ambush billet flywheel ambush billet adjustable coil mount dyno 335 billet cam 28mm mikuni block was milled piston sits .020 out of the hole currently setup to run vp...

Here's one with the correct fender and muffler Sent from my iPhone using Tapatalk

Looking for a rear fender and muffler for a 1970s Holder minicycle Sent from my iPhone using Tapatalk

Bump Sent from my SAMSUNG-SM-N920A using Tapatalk

$350 obo bump Sent from my SAMSUNG-SM-N920A using Tapatalk

BSP block Honda side cover ARC rod new bearings Z4m flat top piston new file fit rings New dyno mod 2 cam Pvl flywheel 4 degree key Block vented Block milled .030 Fresh hone Hemi head .032 copper head gasket 24mm Oko flat slide carb Single stage header All clearances checked Only ran...