Tecumseh H50

Sean B.

Sean B.

Member
#1
#1
Doing a restore on an old Tecumseh H50. This has bearing retainers on it. I have never come across them before. Anyone have any insight on them, adjustment and installation. Can't find much help online. DSCN3214.JPG DSCN3216.JPG DSCN3215.JPG
 
markus

markus

Well-Known Member
#2
#2
IMG_2650.JPG

IMG_2651.JPG

they should be installed on the cover slightly loose before installation, loose enough to rotate with a little play but not enough to rotate past the cast in indentation and spin all the way around. Tighten nuts to 15-22 inch-pounds once you have rotated 1/4 turn clockwise to lock behind the bearing when the cover is installed. the information will be in every Tecumseh L head repair manual that covers the medium frame engines.
 
Sean B.

Sean B.

Member
#3
#3
markus said:
View attachment 281824

View attachment 281826

they should be installed on the cover slightly loose before installation, loose enough to rotate with a little play but not enough to rotate past the cast in indentation and spin all the way around. Tighten nuts to 15-22 inch-pounds once you have rotated 1/4 turn clockwise to lock behind the bearing when the cover is installed. the information will be in every Tecumseh L head repair manual that covers the medium frame engines.
Click to expand...
Thank you very much. That helps out a whole lot.
 
Sean B.

Sean B.

Member
#4
#4
markus said:
View attachment 281824

View attachment 281826

they should be installed on the cover slightly loose before installation, loose enough to rotate with a little play but not enough to rotate past the cast in indentation and spin all the way around. Tighten nuts to 15-22 inch-pounds once you have rotated 1/4 turn clockwise to lock behind the bearing when the cover is installed. the information will be in every Tecumseh L head repair manual that covers the medium frame engines.
Click to expand...
Where could I egt a copy of a manual like this ?
 
You must log in or register to reply here.
Top