Search results

Check pm. Interested

Looking for 5" mag style rim/wheels. Can be complete wheel setup. Taco, Ruttman, LiL, Manco etc... Please let me know real buyer!

I just found one of these bikes and thought it was a homemade frame. I has a goofy weld on top of steering fork and some other funny welds like rear drop outs and fin on fender. I never seen one of these bikes before. Then I actually see one for sale and I now know these were actually...

I have a Tecumseh motor that needs to be picked up, packaged and shipped. It's located in New London, WI 54961. I'm willing to pay for your time and service if you can help me out let me know. I need this motor for a special build. Seller of the motor refuses to ship.

NOS or used. Just a nice tool to have.

Thanks guys.... I found one. This flywheel is actually kinda rare... in the HS40 and HS50 size 1/2" taper I believe. What makes these special is these were on recreational very late 70's to mid 80's Tecumseh engines. Or as what I like to call mini bike specific engine. No light coil. I'm...

Im looking for a HS40 or HS50 Flywheel. Diecast with plastic fins. w/out gears for the starter. Fins can be rough. That's ok. Let me know what you have.

With this style carb. is there a rubber seat that is used or just the special rubber needle?

Thanks you, guys...

Yep! I have been in a slump lately finding these in time. So I was do for one.

Does this carb require the rubber seat. It looks to have a gold bushing insert which Im not used to seeing. And when I add the rubber seat the needle and float sit way off. I checked the obvious. It was pushed in all the way and there isn't already one stuck in there.. Any help would be great!

What is it? Looks like a cat but doesn't have the cat forks and the clutch guard is funny. Has a H30 . Any Idea's what I can call it?

http://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5335845805&icep_item=254159000661

I'm mixed on the topic. I know this, If a bike is parted out. You can help a lot more people who are in the hobby. And if your helping, your making the hobby grow.

I got cover off. Just had to beat it harder. Didn't want to try until confirmed. I'm editing post because I did notice scoring around shaft and inner hole of the cover. Can that be wet sanded a little to help smooth both out?

Thanks! I will keep working at it. So if there is no clip on the shaft, it is safe to assume there is no type of clip elsewhere that could be holding it. Correct?

I have a newer tecumseh That has a side cover stuck. I removed oil seal and didn't find a clip and still cant remove. This cover is being held by something.. Any ideas. See link for a pic. https://drive.google.com/open?id=0Bwi9ewFjlNWPejdVTm81Y0VlRzViT0ZxUGtmUXhoVFB4XzZj

https://www.ebay.com/itm/113313131301

https://www.ebay.com/itm/113313127557

More casted metal usually means older. It's a known fact Tec tried to always reduce materials while trying to solve there heat concerns.