Search results

The bent engine mount plate sat flush on bottom w/ tubes, then slid up in tubes taper until stopped. There were 3 welds per side

Found in AZ last wk. in decent shape, minor repairs and runs. Kids bike till it’s restored.

Anyone know the engine Bug Flea has on this Trial Scout?

Very nice BC Dave!

Hard to find and pretty good Bonanza Cherry repop grips on EBay for reasonable price. If yours are worn or missing, here’s the link-...

I’m rebuilding Sebac Fulton (full size) shocks and have poor dampening on a couple. Can’t replace inner seals if they have. But has anyone tried drilling chamber and adding oil to improve dampening but not leak? Tricks or feedback if not worthwhile appreciated.

Not mine but seen others looking- http://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5335845805&icep_item=304171731286

Midyrman Nice job.

RideSF, did you find a shop that made one? I need same tank and it's a 1 off, so figure need to have one made for my current build.

Find a beat up tank and send to Trailer Products in Hemet and he'll make like new.

They’ve sold for 150-300. Orange one listed for $1,000 on ebay been sitting as it should.

Does anyone have set of the fork wiper clamps for MX-1510. They measure ~1.5” dia. Hope someone can help

A decal shop in Pendleton OR does mine. They were from a Dave Miller build for guy in Idaho. Only other one seen with this scheme. But near clone to Bonanza's Typhoon.

Hodaka Powered Bonanza MX-1510. Thanks Mark Hosinfefer for the project to build. Little sibling to the Typhoon. Next is a Hodaka 80Cc Bug Flea.

Similar to their Typhoon.

I'm looking for original bonanza parts. I live by and bought Azusa Engineering's 5in hub as a temp fix. the lever and plate are not same. It 90% done and like to find these correct parts. Thanks.

Anyone have MX-1510 brake backing and fork wiper spring clamps? Parts not returned from platers:(.

DMC called it Bell Orange, as like the helmet company. OEM paint was single stage and aircraft (70's) grade with chemicals banned today. He gave me a dip stick of color to match. Your close if not spot on with what I see. I could post the color mix if anyone wants, but its on wood not steel...

Call close this. I broke them down and sending out for re-chrome tomorrow.