Search results

  1. Davis

    Blazer, year?

    I’m gonna say it’s a trail blazer seeing the front brake. Should be around a 1967ish.
  2. Davis

    Tecumseh Hssk50 wont fire

    If compression is holding at 65 maybe just mill the head.
  3. Davis

    predator 212 dies when letting off throttle

    The stock rod in a clone will hot seize and feel like a higher rpm jetting problem and will die from drag sometimes. Then you let it cool off and it will start and idle and run but is just a matter of time before it blows up.
  4. Davis

    predator 212 dies when letting off throttle

    Rod locking on the crank when hot.
  5. Davis

    1960? Tote gote?

    Not a Gote. Maybe a sportsman or sidekick.
  6. Davis

    Champion Rocker Cracked intake, Vacuum leak at intake manifold (RTV RED?)

    I’m sorry man and I see everyone else is being nice but that hack job you just caked on your motor is just wrong. If youre going to go to the measuring valve lengths to make thing correct you should go the extra gasket mile.
  7. Davis

    1968 rupp tt500 fresh restoration

    $100 bucks if decent.
  8. Davis

    Help! What kind of mini bike is this?

    Super clean.
  9. Davis

    Opinions on what I am doing to my bike

    That’s going backwards.
  10. Davis

    Opinions on what I am doing to my bike

    Doubt that motor could turn that gear ratio other than pointed downhill. You should shoot for at least a 6.1 gear ratio.
  11. Davis

    Gx200 clone (S170F) block preparation advise?

    @ole sells heads check em out.
  12. Davis

    1970 Speedway Shark

    Only original once.
  13. Davis

    Tote Gote engine replacement?

    Explain relocating tanks? Both of those motors should work fine on a Gote but the orange one will be very low powered.
  14. Davis

    Huskee Hillclimber rolling chassis, need parts

    Crazy cool you got the clutch cover that’s normally the first thing to go.
  15. Davis

    Ruttman Spyder Originality Questions (~1977)

    Welp you’re fancy then.
  16. Davis

    Removing engine water slide decal?

    2000g wet sand lightly.
  17. Davis

    Gx200 clone (S170F) block preparation advise?

    A real gx motor would have a better casting and is a better block.
  18. Davis

    212 Hemi Pushrod length

    If I remember correctly as I did a similar build I used Honda gx 200 push rods.
  19. Davis

    Ruttman Spyder Originality Questions (~1977)

    That sure doesn’t look very far gone. I’d clean that old girl good and run it. Sweaty vintage is way cooler than shiny fancy vintage.
  20. Davis

    Treating rust inside the frame?

    I wouldn’t worry much.
Top