Search results

New build. Hasnt been run yet except after new carb. New air intake. New throttle and rear brake cable. New torque converter. New jackshaft. New shaft sprocket. 41 chain. No pegs, kickstand. Seat has small tear in seam. New tank. Seat needs adjusted for tank. Bigger than my kids can handle. I...

I will take a photo on Saturday and post it. Raining here for second day.

Newer build. Replaced jackshaft. Brake on left side. sprocket on right. new tubes with newer tires. new tank. Still needs rear brake cable. $500 or best offer.

Clark cyclops

Front bracket appears to be 5/16". Rear threaded on brake arm appears to be #12x24. 56" cable. Clark cyclone. Is there a close match to original brake cable available?

I'm thinking of running a wider tubing underneath for footpegs but I am not to happy with how wide she's turning out. A centrifugal clutch would have saved me a little bit. I need a 41 pitch 12 tooth 5/8id sprocket and chain, too.

I centered gc160. New torque converter on left is beyond peg. Right is not much better.

How do you post a photo on this site with pos iPhone?

Turning out wide. I bought frame and engine together. Replaced carb on engine. Replaced air box with aftermarket air filter. Rear brake pin was booger welded on right side. Relocated back to left side with 7018. Bearing flange was cut into. Corrected cut with 6014 rod. Removed some booger welded...

I took the rupp bracket and welded it on inside of frame. On both front and rear face. Then I cut rear wing off. Now I have original bracket on outside supporting swingarm and new bracket on inside supporting bearing. I still have an inch or so for sprocket. Not factory look but it is a clark...

Minibike looks a lot like a rupp. The right jackshaft bracket was cut back. The closest part I could find with swingarm hole on one side and bearing hole was a rupp. It's too small. Clark bracket is much bigger. Now I am looking for correct bracket or maybe using round type on this site to weld...

Sweet. That's exactly what I was looking for.

Most of images that I am seeing show torque converters with fixed pulley edge inboard. I would like to do that, using rupp style jackshaft brackets, which are 8" apart on inside. No backplate.

I want to repair this clark cyclops. It had a jackshaft at one point with right side chain to wheel. Now it has direct chain on left side badly done. Gc160 is set to right. I would like to center the gc160 better and replace jackshaft. Thats complicated with torque converter, which is my...

The comet symmetrical torque converter page explains the second driven unit as hub needs to be installed inboard with pulley on outboard face. Is it possible to reverse the driven pulley so pulley is inboard with hub outboard?

Cool.

Kid that had it really hosed it up. Booger ed welds on forward pegs. Cut right side jackshaft bracket for gc160 and no air filter or cover? New tires but tubes have rubber stems. Needs Michelin tubes with threaded stems. I am looking at replacing jackshaft bracket, ordering torque converter...

Looking like an MTD?