Search results

glad i got my belts for tc88

how much are you looking for? Im not to far from you

good work!! looks real nice :thumbsup:

think speedway primarily used the tc 88

if you can get me a list of what you got i might be interested. Im not far from dearborn either.

guess i was spelling it wrong. thanks

do they have a websit or is it ebay only

snap rings on my bike bearings dont have holes for those pliers. Makes it a real mother:censure:

you can always slide motor foward or back if you have to

14 inch speedway. I got jackshaft out with driven. I cant get bearing off jackshaft on driven side, and i cant for the life of me figure out how to get the driven off the jack shaft. im ready to start :hack::grind::weld:

i put inside calipers on my drive and it did read 5/8. before i did this i bought a 3/4 belt and was a little wide especially on drive. I dont know that my driven is original. Any way let me know what you come up with. How are you planning on thinning the belt if you have to? later

my driven is a 5/8 belt as well. is the 20 series much better then the tc 88

what kind of tubing

looks like its a tc 88 and i need a belt spacer. Does anyone know who carries them? gokartsupply does not nor does mfgsupply. can i just use washers, or does it need to be keyed? thanks

how do i know if my comet drive is a tc 88 or 20 series. Im thinking its a tc 88 cause i just bought a three quarter inch comet belt and it is wider then the brass bushing. Shouldnt the belt be same width as brass bushing. When i put cover on driven and tighten it down, it grabs belt and wont...

Ok, i just got new belt for 20 series comet. Obviously the one i had was the wrong size. However, i got the 3/4 inch symetrical belt, and my question is... when i put it around driven ( which is 3/4 inch from inside pulley to inside pulley at top, The belt just barely fits in around...

what is the web adress? I tried bmi.com.... not it

where are you buying comet belts for 19 dollars? I just paid 32 shipped. Sure would like to find a cheaper source. thanks

either will work just fine

what kind of lube are you guys using, ill be :censure: to spend 20 dollars on comet brand