Lowered and stretched. I welded and powder coated the frame myself. Welded gussets and the axle tabs. Custom hydraulic brakes. Waiting on a sprocket adapter and I can put my chain and clutch on. Everything on it is brand new
I sold the orange one. With a stock motor. I rebuilt the engine that was on it. Doing another motor tomorrow for the white bike. It’s got a smaller cam. A 275. And a smaller carb. Also a different flywheel. The orange bike with the belt system launched super hard. It would wheelie a bit. I got a...
Yea man I used to be able to catch my nail on the pistol with the +20 rod. Now the position is just under flush with the hole. More valve to piston clearance. So I’m safe now….. for now lol. Check out my YouTube channel for a vid of it running.
https://youtube.com/channel/UCAweQcz4U3subKq_RTXzO_g
So I re assembled my build in a new hemi block. My old block had deep pockets almost holes on the head to block mating surface from when I went through 2 head gaskets. So I scrapped the old block and opted with a new fresh one. Also got a new piston,stock length ARC rod and a .47 head gasket...
I’m in Indiana. The non hemi is hard to get here. Hemis all day at harbor freight in my city haha. I have like 3 new in the box. And tbh I went with a non hemi aftermarket head bc I ordered non hemi rockers on accident and couldn’t return them. So I got a head for them. Lol.
What’s frame is the purple bike? metal fab creations? Seen one on there you can order. Also what’s the rear rim,tire and brake setup? 1”? How wide and where do you buy it at.
Well I got another MLS head gasket on the way. And I replaced the valve stem seal. I’ll re assemble it and see if it pops again. If it does. I’ll change my vent hoses around and see what’s up. I’m gonna try an .18 MLS gasket. Everything else is out of stock. I also might order a stock length rod...
Where’s the tank on the blue bike from? It’s dope. And those cages are sick bro!!! My motor has the following:
Big valve 32/28mm hi comp “non-hemi” style head
1.2 billet roller rockers
5.200 chromoly pushrods
Dual 32lb valve springs
Ti-retainers automotive style keepers
Stainless steel valves...
If I had a bad valve stem seal and oil was getting in with my piston with the hi compression my engine has would it blow head gaskets? possibly? Bc I noticed the stem seal was completely fucked when I took my motor apart to repair the gasket. Also had a little oil on my piston.
I’ll be honest I don’t know all of that. I just watched YouTube videos and made it work for the most part. I know the head is a OldMiniBikes big valve hi comp. 14cc? I don’t have any valve to piston contact so I believe with clearance im good there. And my valve cover is an aftermarket billet one. I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.