I've adjusted the idle screw and it helps a little but not enough. When I switch from start to run the back tire starts spinning fast and engine powers up without even twisting the throttle. What's up???
I am wondering what would be the best sprocket set up ( front and rear tooth count) for my doodle bug with a 212 predator engine swap? I am 200 lbs and was looking for a good mix between take off power and top speed. Thanks
I'm having trouble finding a rear sprocket for my doodlebug. I want a 60 tooth and I can't find one. OldMiniBikes doesn't have any sprocket adapters. Where can I get a sprocket???
OldMiniBikes warehouse is out of stock on sprocket adapters and I need one. Any idea where else to get one. Also any advice on throttle cable replacements?
i just bought a 212 predator engine to put on my bike and i am looking for clutches. i am seeing clutches out there that say they are 3100 rpm stall clutch. I'm not sure if it would work for me. i do know that the last one i rode with this engine was so touchy you could barely ride it so i...
I'm sure it's been asked before but does anyone run a Jack shaft kit on their bike? I was thinking about adding it to my 212 predator engine but I wasn't sure if it would be worth the $$:confused:
I bought my first bike and I want to replace the engine with a 212 predator. I was wondering what is a good sprocket set up tooth count and what is my best uptight for a clutch. Thanks for any help. Like I said I'm new to this but it has really grabbed my attention!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.