I just happen to have some nice wheels on hand that I’d really like to use for my project but the bearings are 5/8 so I decided I’m gonna go with them, just a little frame modification and drilling out to 5/8 on the forks
So in my last thread I asked for help with the suspension and I’ve realized that it’s kind of far gone and even if I did get the mounts to fit it’s still scratchy and not what I’m going for. I may get some comments on what I plan to do here but I was wondering if anyone would know where I could...
Pulled a piece of steel off a shelf might try a little fabrication and see if I can replicate that piece and if that doesn’t work then I’m gonna find some real suspension for this puppy
I figured that, I did some smithing and got that straight and just the top bent at a 90 but unfortunately there isn’t enough thread to reach through the top of the fork assembly and take a nut so that’s why I’m looking into “making an upgrade”
Thanks for the tip, do you know if there’s any aftermarket fork arms being made that would fit because it’s hard to source parts and I’m doing this project for a fun rip around and not a restoration. I’m pretty sure Baja warrior arms work as they have the same 1” diameter but those are hard to...
Hey guys I’ve just got into the older mini bikes scene and decided to pick up an old MTD Columbia bike, don’t know too much about it but I have some questions. So in the first picture is the top I’m assuming of one of the front fork arms and I can’t quite figure out what that bent piece on the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.