This build is not going to get done by the end of the month, It started out fun but I have lost motivation. I fab and weld 40hrs a week and this build just seems like I'm at work, not fun. I will finish it eventually as my other commitments get taken off the to-do list.
Good luck to all those...
April update, I started to make the intake 3/4 SS pipe elbow and flanges from SS plate
The seat support will be made out of a set of old down hill ski's, I will remove the bottom plastic and the silk screening on top.
I was looking at compound bow limbs and a corvette composite spring but the...
I'm starting to look at rear sprockets and would like some help on what tooth count would work. The clutch has 12t, the rear tire is 11.250 dia , the engine is 4hp 2 cycle, rpm unknown and I weigh in at 190lbs.
I have a 72t sprocket but is just over 9"dia and just to big for the tire. I'm...
Not as much as I do.
Thanks Guys
Plan on doing the motor mount this week and maybe start on the exhaust. I have to machine the output shaft as it's metric and then start on the rear sprocket.
Thanks for looking.
Scott
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.