Search results

5hp briggs engine

5hp briggs engine

5hp briggs engine

5hp briggs engine

5hp briggs engine

I'm a Christian and prayers are with you Randy...

oldiron- sent a pm. let me know if you got it. jscap99

Injuntom- sent a pm. jscap99

So what happened? Did you get it fixed?

crankshaft lengths As far as adding length to the end of the crank, I think a couple of washers could work. There is a difference of 1/4inch between the two shaft sizes. any more ideas?

I don't have a spacer on the driven clutch. What do you mean by behind the driven? Shouldn't either crank work? It's a difference of 1/4inch. Do I have to cut the (drive) clutch spacer if I use the 2 5/16 crank?

I'm interested in the 6hp tecumseh powersport ohv engines. Some of these come with a shaft length of 2 5/16, and some 2 9/16. A difference of 1/4 inch. I have a tav2 I want to use. Which shaft length should I go with.

spark problem hs50 I played with the hs50 and found the kill switch to be defective. couldn't have been happier. I disconnected the switch and it fired right up. Im looking for another engine for it though. -John

head leak The bolt and threads appeared to be in good shape. I hear you about the sealers. The tecumseh book says not to use sealers. You just make sure the head is true and replace the gasket. I'm going to take it apart soon. When I put it back I'm going to use a brass washer. I might want...

leaking at the head It's a new gasket on there, not a new head. The gasket is OEM and copper. I also used some copper spray sealant. still leaks. When I get to it I want to try truing up the head with sandpaper, although I don't have any plate glass. I also heard you can use a file to do...

silicone What kind of silicone? I might try that first. Thanks, John

silicone used to repair leaking head bolt what kind of silicone? where did you get it. thanks, John

It's a new head gasket. The engine is running like theres an air leak when it reaches temperature. Theres oil bubbling around a bolt where the head gasket is, on the drive side of engine. I might seal it up with this strong stuff since I have no intensions of rebuilding it. I would seal it just...