Search results

yup, that's an ARCO alright - thanks! and yeah, that's a Bird Terra-Torque and a 1200 Sportster on the right, and on the left front to back is a mostly disassembled Speedway Shrike, my wife's Kikker Hardknock, an '86 Honda 450 that I turned into a bar hopper, and my Father in law's Vulcan that...

just snagged this off CL for $100 :thumbsup: starts & runs but the throttle is a little sloppy, was rigged up with a paperclip and assorted bits so that might have sumthin to do with it :out: 3.5hp briggs, newish max torque clutch, scrub brake, chain popped off and got wedged but...

new minibike i just picked up, with a 3.5hp briggs flathead

new minibike i just picked up, with a 3.5hp briggs flathead

new minibike i just picked up, with a 3.5hp briggs flathead

if you do decide to part out, I 'll take that driver unit (should be a Fairbanks-Morse)

i may be interested in this - i have a fairbanks-morse symmetrical driven unit on my speedway shrike, and need a driver that will work with it. anyone know whether these 2 pieces will play nice together? :shrug:

sent you a pm re: that carb & exhaust stub

Portsmouth VA 23701 (part of the Hampton Roads metro area)

just picked up a '93 5HP flathead off SupaFly, it's running decent enough with the tank mounted carb, but i want to rig up the tank on my Bird Terra-Torque: from what I've been reading, I guess I want a Tecumseh H35(?), I found them on the 'bay for around $45 shipped but they say Tecumseh...

Just swapped an OHV Intek for this 5HP flathead from SupaFly: Came off of a tiller, so the small auxiliary drive shaft was used for reverse. It also rotates opposite direction of the main shaft, and at a slower speed (just from eyeballing it, no idea what the ratio might be). Is there...

Briggs 5HP flathead with auxilliary drive

new Briggs 5HP flathead in Bird Terra-Torque

done, I know I'm not the only one in Hampton Roads metro area in VA, as I just traded SupaFly an OHV Intek for a Briggs Flathead last week... :shrug:

Yeah, I'm hoping a fender from Northern Tools will be close enough. Was the rear fender on these the same size as the front? Also, is there any current production tire that would work on the rear of this (but still have the cool lugs?) There's a bunch of cracks along the sidewall but it seems...

Just picked this up last weekend for $150 with a newer Briggs Intek (more on that below). The only issue so far is the rear brake is pretty rough, so I need some new shoes. Also a few of the teeth on the sprocket are chipped/worn. The motor that came with it starts & runs...

Hey, new guy here but I've been reading this site for a few months to figure out what I've got. This here is a Speedway Shrike that I pulled out from under my father in law's collapsed barn this summer. It was my brother in law's about 20 years ago, and the barn collapsed under the weight of the...

testing... here's a pic of my garage. ahhh yes... where the magic happens :scooter:

Speedway Shrike rear wheel. need replacement brake shoes and springs.

Fairbanks Morse symmetrical driven unit from a Speedway Shrike. Need a driver unit that will work with this.