Search results

Will do.

Found this on Ebay, have never seen one before. Not sure if it is what I need. Will research some more.

Thanks for the info. It gives me somewhere to start. They are hard to find complete, that's why I have so much trouble finding anything about them. You have been helpful.

Does the spacer go in the front of the brass bushing or behind it ? Have found out that a pulley clutch is used on the Pac Mule so I may not be using the Comet 20 after all. I am not sure the Comet would work with the shifting application.

I need to put a spacer on my Comet 20 but I'm not sure where it should be placed on the clutch. Any help would be appreciated.

Got it yesterday. Thanks very much for doing that.

I need a replacement gas cap. Any ideas where to start looking ?

Will do. Thanks for all you input and help. Never to old to learn.

I appreciate your input. I wasn't aware that there is a thrust washer, makes sense. It does not show on the parts breakdown but I will research it more. Need a part # to start. I have an old Tecumseh repair manual on order and am hoping that it will give me some details. I think all along I...

Thank you for straightening that out for me. I can just install the oil seal now. I was going off of the parts breakdown for my model # and it showed the bushing, so I figured it was missing.

I acquired an older H50 motor that was in pretty good shape and virtually intact other then a bushing on the PTO side. I have ordered the bushing and received it today. I have no clue as how it is suppose to be installed, which end is which and if it has to be pressed on. I ordered a repair...

Found one Thanks.

Where could I egt a copy of a manual like this ?

Thank you very much. That helps out a whole lot.

Doing a restore on an old Tecumseh H50. This has bearing retainers on it. I have never come across them before. Anyone have any insight on them, adjustment and installation. Can't find much help online.

Thank you, that was a great help.

I have an older Tecumseh H50 that I am going to set the timing on but don't have the specs. I know the points are set at .020 but not sure of the BTDC setting. Any help would be appreciated.

Thank you, I did exactly that. Measured and found some on McMaster-Carr site.

Thank you for the info. My digital caliper battery is dead, so as soon as I get one I will take some measurements.