Search results

You're going to need those round things front and back to keep up with Dave.

Front seat mount will have to pivot and possibly be raised a bit

I had a couple 8 hp Tecs w/ring gears but no starters. The shroud had a bump to allow the worm drive to slide in and engage the the gear. becausee it didn't come with a starter there was a backing plate to covered the internals. From the pics, I don't see a path for worm gear to engage the the...

That shroud has a starter bump for a starter but not that starter.

This is from a Lark

Most likely a Duck, Lark is similar except for the seat

Looks like it has an ID plate under the recoil on the frame.

Lot of similarities to a Fox Sundowner or the like but also a lot of not fox stuff. The fender looks Mancoish.

Does that engine have the ring gear?

I figured as much but it is still a crack up

Dongfang, I thought that was a venereal disease.

https://www.youtube.com/shorts/DnkawuXCy04

Be careful sending him a massage. You might rub him the wrong way

Love the trail tamer type forks.

funfanfin...find

Not sure if this is the same front end or not but I have had it forever.

Try this guy. https://www.ebay.com/itm/147128653409?itmmeta=01KHHPKAGAXSFHJ65ERATJBXD0&hash=item22418d1661:g:JVMAAOSwKfVXE5aI

Scat Cat

When I had my camera repair shop, we used one all the time. We used a special solution for camera parts and the solution will make or break your success. Vevor recommends dishsoap and water, Dawn is an excellent grease cutter. You can also do one end at a time if the item is too big. I once...

Definitely a floor jack but the brand escapes me.