Search results

All I can add to what the others have said, You need to use shielding gas whether argon or Co/argon mix. Stay away from flux core machines or even the thought of using one. My $.02.

Wife and I were looking through old photo albums the other day. I found pics of my CRG race kart, I ran five seasons with it. Fourth season ended up 3rd in the season points championship. Should have hung it on the wall and kept it. Bummer. Italian HPV Iame 100cc 2 stroke CRG chassis, can't...

Be 57 here at the end of October. There are days I feel 107 and days I feel 17. All you can do is make the best of your “golden years”,

Been a while since I've been on here. Put a lot of miles on a couple of these bikes this summer. Last week I sold the orange Tiger bike, made a little profit off it. So I brought the Pecker up out of the basement. I had a slide carb and pipe. Put those on and really got this Pecker pissed off...

Nice score, Neat little project bike.

Very cool, I'd ride it! Unique.

Not sure really. The non hemi is the loudest.

Other two bikes are still in the basement.

Well with summer winding down, Very happy with these two minis. Rode the shit out of them damned near every evening. Both run very good and reliable. Blue bike starts first pull, orange bike on the second pull. No change other than painted the bar's yellow one the orange bike. Had put a...

Maybe I should have said I am going to bring them bikes up. She would have said, "Oh let me help you with that dear" ???

True story.

I told the wife that we have to haul the other two bikes out of the basement to get a picture of all four bikes together. For some reason she rolled her eyes?

Man this bike runs good.

Good eye!

I see a brand new Predator photo bombing the picture.

Put them on the original Richardson trucker hat. Only hats I buy, but that's just me I'm picky how my hat fits. Those hats look thick, really like the logos. Crisp and detailed.

Horse to Tiger

Ticked Off Tiger is D U N done.!

Was kinda thinking that looks like an engine mount plate. Resourceful!

No, I tried. The ID of the sprocket is too small. If you could machine about 1/4" out of each side of the two piece sprocket.