Ya same one same person. There is an extra hole around the serial plate area, so it could have been drilled out. Interested in it. Its yours for the h2.5 you are selling.
What did those look like? And when eere those made According to lil indian fb group they determined mine was a very early century version. 65-67 and should have a briggs. No serial on motor plate. And two spot brake. Also no serial on axle plate.
I just found one of these bikes and thought it was a homemade frame. I has a goofy weld on top of steering fork and some other funny welds like rear drop outs and fin on fender. I never seen one of these bikes before. Then I actually see one for sale and I now know these were actually...
I have a Tecumseh motor that needs to be picked up, packaged and shipped. It's located in New London, WI 54961. I'm willing to pay for your time and service if you can help me out let me know. I need this motor for a special build.
Seller of the motor refuses to ship.
Thanks guys.... I found one. This flywheel is actually kinda rare... in the HS40 and HS50 size 1/2" taper I believe. What makes these special is these were on recreational very late 70's to mid 80's Tecumseh engines. Or as what I like to call mini bike specific engine. No light coil. I'm...
Im looking for a HS40 or HS50 Flywheel. Diecast with plastic fins. w/out gears for the starter. Fins can be rough. That's ok. Let me know what you have.
Does this carb require the rubber seat. It looks to have a gold bushing insert which Im not used to seeing. And when I add the rubber seat the needle and float sit way off. I checked the obvious. It was pushed in all the way and there isn't already one stuck in there.. Any help would be great!
I'm mixed on the topic. I know this, If a bike is parted out. You can help a lot more people who are in the hobby. And if your helping, your making the hobby grow.
I got cover off. Just had to beat it harder. Didn't want to try until confirmed. I'm editing post because I did notice scoring around shaft and inner hole of the cover. Can that be wet sanded a little to help smooth both out?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.