I just found one of these bikes and thought it was a homemade frame. I has a goofy weld on top of steering fork and some other funny welds like rear drop outs and fin on fender. I never seen one of these bikes before. Then I actually see one for sale and I now know these were actually...
I have a Tecumseh motor that needs to be picked up, packaged and shipped. It's located in New London, WI 54961. I'm willing to pay for your time and service if you can help me out let me know. I need this motor for a special build.
Seller of the motor refuses to ship.
Im looking for a HS40 or HS50 Flywheel. Diecast with plastic fins. w/out gears for the starter. Fins can be rough. That's ok. Let me know what you have.
Does this carb require the rubber seat. It looks to have a gold bushing insert which Im not used to seeing. And when I add the rubber seat the needle and float sit way off. I checked the obvious. It was pushed in all the way and there isn't already one stuck in there.. Any help would be great!
I have a newer tecumseh That has a side cover stuck. I removed oil seal and didn't find a clip and still cant remove. This cover is being held by something.. Any ideas. See link for a pic.
https://drive.google.com/open?id=0Bwi9ewFjlNWPejdVTm81Y0VlRzViT0ZxUGtmUXhoVFB4XzZj
Most here probable know about it already, probable even know the member on here. But for those that don't, this website is awesome. I sure hope we don't crash his site. And it sure is better then searching google for the info.
And sorry to those selling the information on ebay.... NOT...
I have a Tecumseh mini pipe exhaust pipe. The number stamped on it is 33222. However, looking on parts tree, ebay and a few others the part doesn't show. I need to know what type of bike this pipe would have been on. Or even what a serial number would have been on a Tec motor with this part...
On a early 70's HS40. Did Ruttman use bushings or seal bearings around crank? Also, does anyone no what type fuel elbow would have been on the carb. for that year/ manufacture? Plastic or metal. My early 70's has a metal elbow but the arm on it seem just a little longer.
I have 2 H35 both within two years apart. Both came off actual mini bikes. true mini motors. both small size bikes. One has a 5/8 crank other 3/4. I have several other small H motors and HS that are also mini bike motors, all have 3/4. Was it a cost thing with bike manufactures when ordering...
No spark when holding plug wire and testing. But have major spark when I use myself as a ground between wire and metal on motor. Checked, cleaned and positioned correctly ground wire against block and magneto. Coil and condenser left. What do you think it is?
Ha guys, I currently have a Fox Doodle Bug/Campus complete Jackshaft assembly on evilbay right now. Thought I would post in case you are needing for your project. Thanks!
https://www.ebay.com/itm/112636045878?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.