Search results

$300 NO shipping Located in PHX, AZ 85021 It's next to the Godevil in the pix Has 212 HF engine, new clutch, front suspension, Honda style seat, will need fresh gas, but runs great

$650 NO shipping Located in PHX, AZ 85021 It's the one in the middle of the pix Runs fine (will probably need fresh premix)

I did not know about the Rupp/CT70 connection. Very cool, I understand why you miss it.

I put the Lifan on the garage porch with the other members of the family (the Heald is still in pieces)

Since Honda, clone, and Chinese all apply, does this bike qualify for inclusion in OldMiniBikes? I think of it as a mini, as much as my 212 Doodlebug and Heald But electric start and street legal are pluses for me as it is my "emergency backup" for a car for getting around. Look forward to trying it on...

Delivered to me a couple of days ago. Just as advertised, very nice original bike. Plan on keeping it clean and running, and being it's conservator. Thanks Trevor!

I know this is an ancient thread, but does anyone have jpgs of the original folding "owner's manual" for the Fuji Go-Devil?

do you have the carry bag for it? shipping to 85021?

use spruce

or info on how to take apart, clean and lube? 15LH 16RH 34/1 3.80 are the numbers on the case. Turns rough and hard. Would like new, used or how to RE-new

seat done.

https://www.ebay.com/itm/Heald-Super-Trike-11hp-Briggs-Bronc-Rupp/183235028674?hash=item2aa9a8a6c2:g:Qk8AAOSwunBbAgbd

tank mount finished. rubber on bottom of tank, and on the wings of the mount.

looks like it should wheelie well!

silver powder coat done. more sparkly in daylight. seat base remade and is at my seat guy (Rex Simon) getting foam and cover.

while the frame forks and wheels are at the powder coater, a few questions: Do you have scans of the Heald Trail Bronc assembly manual or parts manual - whichever shows where washers and other stuff goes? Do you have a recommended source for the belt I will need? Are the TAV cover and...

here's what I'm going to use as a quiet muffler for the hemi that's going in the Heald. Just need to decide how many holes I'm going to put in it. Thinking about thirty 3/16 holes around the bottom face to give the same area as a 1" pipe. Anybody done the used fire extinguisher muffler before?

Great pix! now I'm inspired to put this together. I noticed mine has chrome fenders, a front brake, and a speedo drive. Would these all have been options on the VT-5?

OK Doc, let's call it a VT-5. It sure looks like the bike in your avatar, so if that's a VT-5, then prolly so is mine. Are there numbers stamped somewhere on the frame that will be the last word? After a few measurements, I can see the HF 60363 is not going in that hole without removing the...

Good morning all, I have picked up what I believe is a Heald VT7 (15-6.0-6 front; 18-8.5-8 rear tire) mini. Also went to HF and picked up a 60363 engine. Box and engine don't say 6.5, the receipt says 7hp. $99.99 so yay for that part! Next step will be mounting. PO said I'll need to...