Search results

Hello all, I have a motovox mb10 with a briggs flathead. Stock air cleaner won't fit (to tall). Currently have a weed whacker filter element rigged on but does not stay in place. Also had to crush down one side to fit. 5 hp looks and runs great but clean air is crucial. Any help or suggestions...

Good to hear, thanks for the reply.

Hellow to all. Wondering if anyone has used the Harbour Freight small flux welders and if so would they work for small tabs on frame and the like. Thanks for any help.

Thank so much for that video. Never thought to use same set up for drive as mower blade engagement.

I have a 22 HP Honda motor from an asphalt road cut saw. What can I put it on? Thanks for any help.

Thanks, I saw that back when we got the bike. I just put a caliper and pads on it and it is no different. I can squeeze the sh## out of the lever and almost nothing. I don't think it is the rotor, have you used this system?

Hello everyone its been a while. So got my kid the mini when he was younger. We got an MBX 10 and put a 5 HP briggs in it. Now he is 15 and still riding with friends but the brakes never really worked well almost not at all. I wan,t to juice it up for him and was hoping someone might know how I...

Thanks to all.

Hello, back again with another question. The kid and I put a 5 hp flathead on the MBX frame. Thing runs great but after months of adjusting and pad replacement I realize this is truly a garbage setup. We were wondering if anyone has used a band/ strap brake on the clutch or maybe put a 4"...

Hey Butterbean, same deal. the engine is yours for the cost of shipping, I will try ebay for the clutch. Let me know if your interested.

Engine Hi, I have a motor from a Motovox MBX10 we swapped out to a 5 HP Briggs. Motor, carb linkage all there. The key slot in the shaft has a sloppy spot but still works fine. (longer key if needed). My son is 190lbs and that 97cc just didn't cut it. I purchased a new clutch for the mini at...

I've got a max torque I bought at nappa for $45. I put it on an MBX10 for 2 minutes, pulled the motor off and put on a 5hp briggs from my wood chipper. You can have it for $25 plus shipping.

Thanks to all, found some 24 galvanized pole bolts at work. Cut of square head and threads, a little heat and a hammer and all is well. I left the rod in the tubes so I fell better that they won't collapse on the kid. I think I'm hooked, just found a Manco tbird not running on craigs list fpr...

What happened Hello everyone, does anyone know of a bolt on or retro fit front end for this bike.

I hate computers. If u can please see my photos.

Bent forks

Bent forks

Bent forks

Hello to all. Kid didn't listen again. Pulling wheelies in the back yard and he put small kinks in the forks just below (1 1/8") bottom tree. Does any know of a bolt on set that would work on this mini. We tossed the 2.5 hp and put a 5hp flat head. I see you can't buy MBX11 front end yet which...

Hi, hope i"m in the right place. Made a call, stated my case ordered a clutch and can' use it. I ordered a Noram star 1" 13t 35 chain for a father son project. We have a B&S 5HP w/1" shaft. I need the clutch to run inboard for proper alignment. The clutch we received is counter bored and has...