I was directed to a source for what’s needed.
I’m a tool and die maker and could make them but it’s easier to buy them when I only need 2.
Thanks amigo!
Searched here and in the intertubes, not getting anywhere.
Looking for a brake cable where the conduit is 80" (?) at least.
I can trim to fit.
3/8 Barrel is a must.
Who sells them?
Thanks
Kevin
Looking for a blank rear sprocket, #40, 48T (or a little less) with a 1-5/8" (1.625") Bore.
I see some I can fab to work but I would prefer something I just need to drill the mounting holes in and call it a day.
Thanks
Kevin
I have a MB165 Baja Warrior ... metal fenders and metal fake tank.
Just got a new seat and its too narrow. It wont go down to the frame, it sits on the frame and lower lip of the seat on the seats edges.
What am I missing...
odd you should mention that ... the original motovox motor tossed its flywheel magnet and broke the magneto mounts and has to be replaced. The Lifan 3.0 was the motor to take its place only problem was the gas cap was positioned under the seat so I swapped it out with the motovox tank that has...
4 Years and 2-1/2 months later here is an update on Dorothy!
We started moving about 3-1/2 years ago. We are out in the country 3 miles from any paved roads. It was time to revisit Dorothy.
In that time I have come to appreciate the Predator motor so the Tec got swapped out with a 212, air...
8 or so years ago when I was buying parts from OldMiniBikes they would literally toss them in a oversized box loose and if something was missing they would reship. Took about a week to get to me in Michigan from PA.
Fast forward to the last couple years .. the packaging is off the hook, well wrapped...
I'm a die Maker, I can Tig.
I have no Mig experience.
I'm just going to be goofing around at home .. is there any reason I would want to go Mig instead of Tig?
I assumed I had bought a bad battery last year so I went with a new one from a reputable store.
If that hadn’t worked I would have posted this up asking for help.
I also posted this up on my FB page .. a friend who owns a small engine repair shop said to always check the lash and if it’s good...
I bought a used Craftsman 46" cut with a Intek 21 hp single cylinder early last year.
From the beginning it was very hard starting, thought it was the battery .. bought a new one and it helped a little.
I would turn the key and if the battery wasn't FULLY charged it would stop against the...
Here: its almost a race to see who can provide the correct answer the fastest.
Facebook: a bunch of answers come in and the poster chooses which they like best weather its right or not.
Sorry about your bad luck Skipp.
I've always found OldMiniBikes to be the last bastion of sanity in the mini bike world. Check Mini Bike Nation and you will know what I mean.
I was entertained with the seller talking 90% complete while were looking at it ... I could clearly see it was junk ... I just...
Hilltoppers, gotta love them!
I have done considerable work to both mine while keeping them dependable, safe to ride on the street and keeping the original look.
If you need your seat done correctly manchester1 is the resident go-to member and very likely one of the worlds best who reproduce...
I agree with piglet, the piece you found will work. However I would keep an eye on it and the band for excessive wear in case its soft and wears quickly or it tears up the band.
How much you ride it will also be a determining factor.
I also have 2 Hilltoppers.
They are street legal and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.