Search results

sorry for the delay in responses.. im fairly busy for a little... how much of a stretch are you wanting to do? yes the rear tire on it is on the stock wheel... the tire is 13- 6.5(wide)... but that would prob push the limit on width if you are using a hyd brake in the stock position and the...

speaking of which... little more done to it... but havent done a real write up on it... going to wait until i stop on it and then post one... .875 OD (083) but I also use tubing inserts at the welds.... i do show this on FB somewhere on the OldMiniBikes page... but will do a write up here, when i stop

thank you

thank you

some polish on them

little progress since they had been sitting...

threw a ton of stuff i have laying around that i dont want and yes, it can go to someone else.. i have no desire to keep it.. little more dont to it

thank you i have mig welded for quite some time... but i def like tig welding better... i guess if i were in a rush or having to do part after part, of mild steel, i would def want the mig... but whenever i can, steel or other metal, i prefer tig... much more control and versatility with it...

ironically this bike has recently been cut up... had been taken apart, parts gotten rid of or given away... and frame sat for a while... this past week i took a bunch of parts i didnt want, or want to get rid of.. and put it on the bike, with a few small changes... how it is sitting right...

you can just use tubing, or pipe, with the correct id for the axle and cut to length

thank you... I think it is much easier than being able to write withyour left and right hand at both times.. more like being able to draw a line with your left and right hand... or circle etc.. but easier than say writing letters with both hands at same time.. if that makes sense... i can hold...

thank you...

made the wheelie bars up.. can figure out where to nitro us bottle now... and mount the tanks (catch can and fuel cell)...