I sent this guy an nos speedway fork boot to make a mold from and he’s selling them now on eBay. These are for all 14” speedways and 72 and up 10” speedways. They turned out perfect and I can’t tell the difference from my nos one...
I’m looking for a replacement headlight bulb that I can use in my 74 aermacchi x90. It has a 3 prong connector and needs to be a hi lo bulb. The original is 105mm. I set the one from my rupp in it and it seems to fit good but it is 12v. Thanks.
Hello. I’m looking for an early hs50 aluminum lighted flywheel. It’s different than the hs40 and would of been on a 72-early 74 I believe. Here’s some photos.
I’m looking for someone who can sand-cast an aluminum brake plate for me. I am missing the rear one but can borrow one. I have looked everywhere and can’t find the right one. This is the only part holding me up for my speedway super spyder restoration. Please send message or email me directly...
Hello,
I need an hs50 3/4” non ball bearing crank. It does need to be the smaller taper smaller thread ones that was used pre sometime early 80’s I think. It’s ok if not drilled and tapped but I prefer it to be. Thank you.
Hello,
I’m looking for the rear brake plate from an mtd duster. I will pay top dollar for one or buy a whole bike. Will also pay a finders fee if you know someone that has one. These brake may have been used on some of the big fox bikes.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.