Search results

Still available

Thank you

Looking for ideas for how to mount a minibike from a wall.

Looking for a usable Arctic Cat Gas Tank.

Very original condition. Parakeet yellow. Starts,runs and rides as it should. Lights work. Has scratches dings and the usual patina. If you are looking for an unrestored z50, here it is. $1800 262-456-2225

Sounds very familiar. It was a crankshaft seal that solved my problem. In my case it was the flywheel side but I changed both sides. Any bits of metal must be cleaned up from the broken ring.

Looking for a usable HS40 Blower housing. Prefer the points style

Engine recoil cover decal. Says Arctic Cat

Looking for a decal for an Arctic Cat Ramrod

Yes it is . They are hard to find because they changed the design and had a recall to change to the wrap mount. If you are going to ride the Climber I would use the wrap mount. If it is more for show then the bottom mount is ok.

If the bolts go into the tank it is a bottom mount. If the mounts are under the frame tube it is a wrap mount. Early Arctic Cats (1971) had bottom mounts and good tanks are hard to find. Wrap mounts (1972) are the better way but you need to weld in new style mounts under the frame tube.

Bottom mount or wrap mount?

Thanks. I was worried because they had no baffle. I ordered one.

Need an Exhaust pipe for a HS40 slanted Rupp 1971 and up

Yes that will work. Be sure to disconnect the capacitor wire.

I use the stock pilot and tube with a 100 main with great results. GX 160, 18lb springs, gov delete, billet rod, header pipe and high flow air filter.

If you want to check the compression on an engine with a bump cam you will need to spin the engine backwards.

The two sets of sleeves I bought off Ebay are just plain too small on the I.D. The springs and dust seals are good though.

Yep. The sleeves are crap. Clean up a used original set as best you can and go with that. I have got years out of used sets that I thought were worn out.

Engine looks right. They didn't have chainguards though.