Search results

  1. S

    1960 Percival Hellcat

    Gaskets are available for the carb. Measure the float bowl diameter and i can tell/send you what you need.
  2. S

    Wanted: Clinton #46-674 (403171) Crankshaft

    That is a left hand E65 crank. Looks fairly decent. Why do you want to replace it? I have most parts to get your E65 going. HIt me at terryas@att.net
  3. S

    Clinton A490 Panther

    I have a used coil with the same number, 5733, on it. I get similar Ohm readings. Yours if you pay shipping. Priority small box is 10.40 I believe. Throw a new set of points at it.
  4. S

    Clinton A490 Panther

    Ok, I’ll see what I come up with
  5. S

    Clinton A490 Panther

    I’ll look tomorrow and I’ll see if I can check ohms resistance on one. Hard to diagnose
  6. S

    Clinton A490 Panther

    Show me what you have
  7. S

    Clinton A490 Panther

    Go to ebay and search for: Timken - 470601 That will get you to a seller that has everything you need. 471646 is for the A400 PTO 470601 is for the A490 PTO 254270 is for both bearing plates
  8. S

    Clinton A490 Panther

    A400 or A490? PTO seal is different
  9. S

    Restored Flexo Scrambler with perfect Clinton

    If I remember correctly, a buyer bailed on me and I wound up selling the engine and the bike separately.
  10. S

    Adjusting a Clinton Panther 500 with LMB carb, driving me crazy.

    Clintons are my favorite 2 stroke. Not fast, or powerful, but we had a go-kart with one in 1958. Factory said 16 to 1 after break-in. Even with newer oils I wouldn't stray too far from that. That muffler is very restrictive. I usually drill a few holes in the end.
  11. S

    Clinton Panther 500

    I have 233-114-500 and other parts. pm me terry
  12. S

    Wanted Clinton 20-41 bushing

    It's Terry (scrambler1) again. If you have an A490, you want the ball bearing 20-4. Also known as a 6204 open ball bearing.
  13. S

    Hey Spyder4 speed, Yeah, I saw the post from Dave and the pictures of your engine. It looks...

    Hey Spyder4 speed, Yeah, I saw the post from Dave and the pictures of your engine. It looks pretty rough on the outside. I'm not sure if I can save it for a reasonable cost. Sorry for the bad news. terry
  14. S

    Clinton A400

    I have stubby Clinton headers
  15. S

    Clinton A490 Panther

    Still looking? I have parts
  16. S

    Restored Flexo Scrambler with perfect Clinton

    Price drop! $1950 + shipping If no takers, I'll just roll it back into my office
  17. S

    Restored Flexo Scrambler with perfect Clinton

    Price drop! $2050 + shipping
Top