Search results

  1. P

    t 555

    Could use a rear end for this , anyone ?? Thanks for looking
  2. P

    unknown project i.d. help needed

    What do I have here ??
  3. P

    Tri Rod engine help needed

    Hey , 7hp Briggs , drove it a couple times ( surprised by how good it drove) , went to the hardware store and on the way back had to get towed. Fired right up again but when I gave it some gas , it would die. Had it on the lift , had carb apart twice , sprayed for intake leaks , for s#$@* n...
  4. P

    Tri Rod belt help needed

    Hi all , My drive belt is really stretched. Anyone know where I can get a new one ? Part number ? Other than that , it is rides surprisingly good ! Thanks
  5. P

    Tri Rod

    It's not painted yet but , I'll have to wait as the crap just keeps piling up and I have to move on.....for a while. :rolleyes:
  6. P

    help/advice 3ww

    Hi all. I have tried getting on at 3ww (they have a forum for these) and can't. I have an early 80's Yamaha Tri Moto 125 and I am trying to figure out the pull starter. There's a spring (I think is broken) and a "pawl". I just need a good pic of one that works properly , from the inside , with...
  7. P

    A shot in the dark - Need Yamaha part

    Hi all. Looking for a pull starter for an early 80's Yamaha 125 3 wheeler. Any help?? Thanks
  8. P

    Tri Rod shocks and stickers

    I can't find any replacement shocks. The ones I just got are too fat and too long. Any help?? Does anyone repop the Tri Rod sticker? Thanks much
  9. P

    Tri Rod part id

    What is this for ? Looks like a holder for a flasher but nothing was there. Thanks
  10. P

    Tri Rod electrical

    Were these 6 volt or 12 ?? The solenoid says 12 but , someone could have changed it. Thanks
  11. P

    Tri Rod help

    I'm finally putting mine back together ! Does anyone know if there are some repo rubber "donuts" for the axels on the non solid axel machines?? Mine are fairly well cracking. Or would I need to go to a steel u joint ???
  12. P

    Tec starter problem

    Hey all . I have a Tecumseh HM80 and I put a 12v starter on it and now ,while trying to start/tune ,I can see it is chewing up the rubber part (in red). Like it's coming out too far. Or should there be something for the nose part (circled in blue) to stop it??
  13. P

    Tri Rod help needed

    Hi all. Newbie here. I just picked up this Tri Rod and know absolutely nothing about it other than it has a 8hp dual circuit electrical system. It also has dual shocks all around and a rear independent suspension. Anyone know if this is the original engine?? It looks like each rear brake has...
Top