Search results

Brought home another Simplex. Due to the modifications the last owner did, I'll go a different route on this one. I'll try to keep the post updated on the progress.

Anyone reproduce Fantic Broncco tx7 seat cover?

Couple simplex spitfire and the progress.

Looking for a rim for a MTD minibike. 10" or 12" if front or 10" for rear. Looking for one in nos or good condition

Looking for a 10" 20 spoke rim. They were used on Simplex minibike, mtd minibike, Indian 50cc, italjet bamboo and etc. Redoing a Simplex spitfire but rims are rusted through. Thanks

Any thoughts on this go kart?

I believe these were made in 75, anyone confirm? Thanks!!

Anyone have any info on this Kart?

Anyone have info on a 1968 simplex fun kart? Odd seat for a go kart.

Did they put sprockets on the K&S Hornet deluxe? Most pictures I find have a belt setup. Thanks I know it's the wrong engine for the bike, not sure about the jackshaft setup

Looking for a 356 (631588) diaphragm carburetor for an old Fox banshee. Thanks

Found this complete Fox Banshee and thought it was an Extra, then noticed the engine on the Extra and Super were flat. Mine is at an angle, diaphragm carb without a jackshaft, All other Banshee I can find have 10" wire wheels. What do y'all think? Thanks

Anyone make make a reproduction or you weld it kit for the powerdyne forks with springs? Thinking about putting them on a Tubesing Corp mini bike.

Anyone know anything about the Tubesing Corp. Ram 500 model? They were built in Decatur Georgia. Trying to see what the seat, chain guard and etc looks like. Thanks for your time,

Anyone heard of Tubesing Corp from Decatur GA? Trying to get some info on my bike. Thanks for your time, Erwin

Good morning all. Having g a hard time finding info on what stator and flywheel (or magnetic) combo to use on a Tecumseh h40 (55806a) 4HP motor. Putting it on an old Rupp and no room for batteries or such. Thanks

Does anyone reproduce the early rupp gas tanks or chain guard? Thanks