Need a Lil Indian expert to provide some info for my frame stamped 10888. Seeking info on a number of things including:
1. Year bike was built.
2. Bolt hole size and spacing for both fender braces.
3. Brake cable dimensions and distance from caliper bracket, since mine is missing.
4. Does...
I recently picked up a 1974 5hp Briggs 130202 off an old tiller. Tank was pristine with no varnishing or dirt so things were looking good. The sheave on the PTO end was seized so I ended up cutting it right through the key way and wedging it off only to discover the shaft to be about one inch...
No where in the can does is say either fuel proof or fuel resistant.
No where on the can does it say either fuel proof or resistant. I’ve been hanging on to these can for several years and this is the first time Im using them. I’ll have run a little sample on a piece later this week. I’ll let...
Cylinder was mic’ed within tolerance along with con rod bearings. Sand blasted, primer’d, painted with 100% pure stainless paint and cleared. Stacked everything back up and decals last. I’ll let this paint set up for several months before firing up.
Seeking new or old 1968 taco 44 brake/sprocket set up. Attached is a photo of what I need. And if the Carlisles are on them I’ll take them too. Thanks!
So far your rebuild is looking good man! I’ve got a 5hp Briggs on my bench right now. Good to see what else is going on in other guys’ garages. Did you blast the block or stripped?
Picked up this 1966 5hp Briggs off of an old chipper. In the process of doing a complete overhaul to put on my Taco 44. So far the I found the carb to be cracked at the flange and bought a replacement along with gasket kit and electronic ignition to replace the points and condenser. Open to any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.