Is it a horizontal shaft engine? What equipment did the engine come off of? Some frames are too small for anything bigger than a 212. Most OHV engines are a lot smaller with a custom gas tank and exhaust.
I was just given a 1950 Craftsman 131 mower which has a Power Products AV47 two stroke on it. Probably the same as your AH47, but vertical shaft. The recoil is just a two foot length of rope that you wrap around the pulley and then pull it. You would put the length of rope in your pocket after...
Lightning Rod Seat
I do have to say...the lawn edger height adjustment lever/rod to engage the drive wheel was pretty creative though.
Pull start housing does not fit?...Just leave it off...
adjustable foot pegs
gas cap, air filter and muffler is extra. Footbrakes included with rider...bare...
It looks like your picture shows a short tank common on the low hp engines, which works great to clear the tire on minibikes. People are giving away edgers with those small Briggs engines all the time. Maybe keep an eye on craigslist FREE section.
We see a lot less rust out here in...
Heald Super Bronc VT-8 with a rotted front tire
Fork ends have tubes over the front axle so it looks like I need to drop the forks to get the wheel off. Since it has a front drum brake, unscrewing the axle out one end seems like it is not an option; also I doubt the axle is threaded all the...
Even though the maximum Center to Center is 1/8" smaller than mine, I decided to give one of these cheap belts a try to check where I am at on size:
http://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5335845805&icep_item=112601686431
I have heard the cheap ones do...
Skipp...your chart is for for the Comet TC88 with symmetrical belt and the Comet 30 is asymmetrical. So my post #4 should have had the belt numbers of 203591A and 203592A.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.