amount

If you mill your head .030 to .080 would also want to shorten your pushrods the same amount to keep the valve train geometry in check. Or is this really a big deal cause you can adjust lash to correct the amount removed from head surface. just a thought i had . Anyone know or comment ?

I have a built briggs motor on a 15 degree mount. How many ozs of oil should I be running?:shrug::shrug:

There is 2 oil fill caps and drain plugs on this motor, how much 4 cycle oil do I add back in after drainig it? thanks Also. I got it running yeaterday after sitting for years in garage. Cleaned the carb it it ran great for a few minutes. than I shut it down and degreased it to clean it up...

Looking for some small pieces of 1.5" OD tubing around 1/6" thick or so. 6" or less would be fine, I only need two 2" long pieces. I found some online, but shipping is $15 for a $4.50 piece of tubing. Throwing this out there to see if anyone has some scrap laying around that might fit the bill.

I have an NR 285 cam in my gx200, larger 28.5mm inlet valve, 26lb springs. Will not be letting it rev over 7500 rpm(max). With this rev limit and these components, what would be a safe amount of lift, meaning how much ratio dare I put into the rockers with these springs. Regards.

My booklet manual mysteriously came up missing to my HF 6.5 engine.Can you please tell me what oil weight and the amount to use.Thanks.