This is pickup only here in Englewood FLA. giving it a shot before it ends up at the curb on garbage day.
My buddy had this got it in a parts buyout, Supposedly they were going to build some sort of step thru spoke wheeled scooter with it, maybe like a large "broom cycle" or something like...
I'm changing out all the wheel bearings on my Murray Track 2, and the rear bearing seat on the sprocket side is warped. When I tapped the bearing, it practically fell out. Any suggestions on how to fix that?
Ok so I touched on this in my project thread but I know that isn't the place for questions. I bought a 12" rear wheel on ebay to replace the 10" in. the bike came with and it came with axle, bearings and spacers. Plus those oblong washer looking things with the tabs sticking out. When I...
Thinning the herd!
Custom built 1968 Taco 99 Trail Tamer full suspension minibike with race modified Briggs 5hp engine. One of a kind auto restoration quality restomod by OldMiniBikes member Havasu Dave, I bought it this last summer and rode it just 5 times. Loud n Proud this one. Pretty close to show...
Anyone know where I can get some better quality wheel bearings and steering knuckle bearings for the MB200? Not just OEM replacements, but better sealed and maybe better material bearings?
This clutch would have been top of the line back in the day. Heavy duty metallic shoes, needle bearings.
5/8"crank, 40 series chain, 10 Tooth...NOS!
$35 shipped
Hello,
I am putting a HS40 together for a friend and there is a clip that holds the crank bearing in place that I want to leave out. It doesn't look like it is needed. The clip is on the clutch side between the crank bearing and the seal.
Any input or advise is greatly appreciated...
I want to use something like this for a project im into... had i had them with my project Repo, they would have come in handy.. they dont have anything like this available for 1" axle... or this style... so hopefully i dont have any bumps during "testing". i have a couple more repo style...
Hope everyone is doing great. I need some help finding a 3rd bearing support type setup for a gx390... I found something on Burris' site, but they are not open to ask questions, on whether or not it would work for a gx390.
im hoping someone else has done this and or knows where to get...
Hey guys I am fixing up an old mini bike and was changing the old wheel bearings. I was trying to put the new bearings in the wheel and couldn't get them in .So I used a dremel and grinded out the inside of the bearings to make them fit. I noticed a little wobble on the rear wheel and then...
I finally got around to taking the wheels apart on the homemade mini bike I picked up last month. I think the rear wheel came off a late 50's kart (bases on some pictures I saw on EBay. I a pulled 3/4" axle out of the rear hub. I am not a home to measure it or post up some pictures but, does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.