bearings

  1. J

    B&S Raptor Engine Pricing?

    What seems to be the going rate these days for Briggs & Stratton Raptor engine that is still new in the box? This engine was sold new, unassembled & it is still in the same condition. I don't know very much about the Raptors. What is so special about them & how do they compare to a B&S 5HP...
  2. minibikedude

    Kawasaki coyote fork neck bearings

    I pick up a rolling Kawasaki Coyote frame at Portland ID. Show for 35.00 bucks and it is missing the fork neck bearing and bolt. The bearing I seen for them is a F PCO 40 BY FUSI the size is 40mm OD and 17mm ID. and the 17 mm bolt and nut that 6.5 inches long to hold it together. Not having any...
  3. Dupa

    Speedway Scarab Bearings

    I went to remove the jack shaft bearings have and found they have been tack welded in place. Any input as to how these should be mounted.
  4. R

    Tri-sport rear bearings and holders?

    Hey all, I have an early 70s Alsport tri-sport and when I got it the axle was not attached to the frame. I may have to replace the entire axle because it looks like one hub is welded right to the axle.. but anyway The bearings on the axle look normal but they are held to the frame by...
  5. poorboy

    Bearings

    Hey, as luck would find it...My dad found some original 5" rims from one of my old minibikes...these are steel two piece rims and I'm going to use them on the Atlas.... Question 1. these rims have tappered roller bearings (timken USA) that are shot... I measured the OD on the hub as 1.75...
  6. J

    Need education on quality Chains, Clutches & Bearings.

    In the near future I will be needing to buy several feet of chain, a few clutches, bearings, jack-shaft assemblies, etc. Who makes & sells the good stuff? I want to buy good ole "Made In The USA" products as much as possible. I would like to standardize & use #35 chain on everything. At...
Top