belt

When I first put my bronc together I asked Ron at power tec on what belt I should use for my super bronc, He told me the comet #203591 belt was the correct one. I remember installing the belt and it just "plopped" on without having to spread the driven sheaves and was a fairly loose fit. I...

How do you make sure u get the correct belt size on a series 20 comet torque converter

How long are you guys getting out of your tav 30 belts? I put a brand new one on my bike last year in november, It has mostly road miles on it and maybe 10-15 hours? I put on a new spare belt today and I forgot how smooth it was. I compared the old belt to the new one and it looked like...

I picked up a very old comet torque converter today. It reads 20 on the driven clutch(not shown) and reads V-PLEX on the driver. I was wondering if anyone had any information on the exact width size of the belt. Thanks

I have a TAV 30 the one with the cast back plate and I noticed that the holes to mount the belt cover are not tapped is this the way they all are? does it use self tapping bolts?

I have a slacking torque converter and i think its the belt. i am not sure if the size is right. Those of you with torque converters that have the right belt size, can you take your belt off without disassembling it or anything. just pulling/wedging it off. cause i can

Well i had a torque converter and did a burn out and after that tthe performance suffered horribly. so i replaced the belt and no improvement but the belt was probably to big. The converter was really old so i decided to replace it. put the new belt on and it worked great although i think it was...

I need replacement drive belts for my R2 and Hustler. Does anyone have a good Dayco pt# for the belt. I know Brandt has them, but I don't necessarily need one with "RUPP" on it. Thought I'd be able to pick one up a little cheaper from the auto parts place. Tom.

I have a 7 inch driven series 30 with 3/4 bore for 60.00 15.00 to ship in the states ,,

Hey All! Can someone tell me how much play should be in the front belt (From Engine to jack Shaft Pulley)?? Thanks HeartLand USA

I've been lurking for a bit now; GREAT site. Thanks to all. I need a part # for a super bronc vt10. Throwing special order belts at it at $20 a pop isn't working for me. Can anybody help? Asymetrical comet. Thanks-Josh

got the belt drive on my columbia today. 2 1/2 inch pulley on engine to a 3 inch pulley on jackshaft then ten tooth clutch on js with 41 chain to rear sprocket. belt is a 4L260 with no slipping so far. with this setup i can now climb the hill in my yard but i did give up some speed. runs alot...

Three engines [2 HP Briggs] in a homemade frame. Engines coupled together by "V" belts. Jackshaft carries centrifugal clutch. Final drive by chain. Has electric starter [off an 11 HP Briggs] on first engine as it is impossible to start unless at least two ropes are pulled at the...