chopped

Looks like a Taco frame. Handle bars are throwing me off though. Guy has the forks chopped off below the springs as well.

My son picked this up.It looks like a Roadster but no T/C. there is a chrome clutch cover that says Rupp on it and the frame has the jackshaft mount. It has funky skinny shocks and forks, came with extras including exhaust and another seat (Rupp). Did Rupp make a cheaper T/C less model like...

This looks like a very original Red Baron from the front to just behind the tank. Obviously, it has been chopped and fabricated as a hard-tail, but I kind of like it. I plan to leave the rust and just get it running & riding. My question is how to tell if this was originally a 1973 or 1974...

chopping time

Went a bought a Kart, we played with the carb a little bit, it's running and chain rolling, got too close and pinched the end of my finger between the chain and sprocket... :censure: blood all over the place.. after a minute of messing with my finger, and knowing the kart doesn't idle the best...

so was gonna do a restore and have a lot of parts for that but after i rode my bros bike gonna do the same things but gonna put inserts and stretch the frame by one inch for the tecumseh then sleeve and gusset the swing arm mount and use a 12 mm bolt here is my starting point just wait for all...

Easy to figure out what this bike originally was, but someone did a 'creative' chop job to it. vintage mini bike

So seems someone had the notion to turn this into a chopper. Would adding more tubing where this is cut give you the right rake?

So after an incomplete build on my last go kart, and having found a quad frame and 250cc engine for $80, I chopped up the quad, put a riding mower seat in the middle, bent down the steering, threw an engine plate on, and now I'm up to something rideable, but theres stuff I still need to finish...

While waiting on the last few parts for my MB165 that I'm adding rear suspension to I got bored. And after looking at this bike I noticed the rear part of the frame was bad crooked and the engine plate needed some welding! Some how it turned into a whole new project! :hammer::shrug: So I...