dead

Don't read it unless you want to knwo how the series will end. http://en.wikipedia.org/wiki/The_Walking_Dead_(comics)

Any Dead Heads out there? If so, you know what this is. :wink: This belongs to my kid brother, Tom.

:confused: DAMN... I guess so many deer dying of this (Blue Tongue Virus) that they had to fish 1,000 corpses out of the dam, because the dam was plugged up.... :mellow: That's a lot of damned deer..

So I'm trying to set the valve lash on my 6.5 Honda clone. How do I determin TDC on the compression stroke? I used a flash light and watched the piston till it was at the top. But I'm not sure weather it's the compression stoke or not.

Wtf is going on?

What do you guys tell your wives when you bring home another mini? I mean, I can't buy her flowers and chocolate because I just spent all our money on this bike. Just kidding fellas. What I really want to know is what it is? Is it a bird? The 3 1/2 tecumseh is new along with the clutch...

The kids have a new bug for X-mas. The issue is its starts and idles but won't take throttle... Choke is not on... I'm fairly handy but not a wrench... Any suggestions?

rip dan! i cant believe this

:surrender:

R.I.P......:sad: Randy Macho Man Savage Had a heart attack while driving and hit a tree. Dead at 58 .

As the title says...might wanna tune into the news now !!!

This is a short video of me and my buddies trying to get my doodle bug ready 1 week before the Ventura race. I was trying to get these dual gas carbs tuned. But I end up switching to a single alky carb instead. This isn't the best quality video, it was recorded with my cell phone. YouTube...

drug overdose, no surprise there. Corey Haim Dead After Apparent Accidental Drug Overdose - ABC News

what could go wroung if the valve lash is not set when at top dead center

YouTube - The largest dead snake ever found, over 50 feet.

had a problem with too much compression after installing new springs/head. i checked the lash gap which looked okay but wasn't fully cycling the piston to recheck. right now i'm eyeballing tdc but when you guys start doing more and more mods can you get away with doing it this way with just...

i apologize for posting this again but does anyone know how the :censure:to get in contact with rupp parts.i ordered over three months ago and recieved nothing.i have called 50 times and got the machine which says leave a message then proceeds to tell you his voice box is full(go figure).i have...