driver

  1. X

    comet 30 driver

    Looking for a used comet 30 series driver that is 3/4" bore. Any leads would be great. Thanks.
  2. X

    1" TAV driver clutch

    Ok guys, I picked up a TAV 2 the other night and it is for a 1" shaft. I do not have a 1" shaft engine nor do I want one. I am looking for someone who needs one of these and that has a 3/4" TAV driver that will trade straight up with shipping. Anyone? I think it is a good deal for anyone...
  3. 125ccCrazy

    Will a Comet 20 series driver work with a MT 20 driven?

    Both have a V configuration with 13 degree sides for a total of 26 degrees, only thing I can see may cause trouble is I believe the MT uses an 11/16" top width belt and the Comet uses a 3/4" top width belt... I am not sure if using a comet belt (3/4") would cause the MT driver to grab too soon...
  4. jmbmini

    Comet driver clutch 5/8 shaft

    This is a new clutch it is a 5/8 shaft series 20. I want 30.00 plus shipping. In Ohio. PM me. Thanks
  5. Modding_out

    30 series torque converter driver problem

    I recently acquired two 30 series asymmetrical drivers, the old one is missing a few small parts, and the one is perfect except for one small problem.........if you would refer to the pic:http://www.comettorqueconverters.com/asymapp.htm < (1/3 the way down the page) Part number 8, is suppose to...
  6. DZLBIKE

    Salsbury Driver

    Hello all, I need a Salsbury driver for a little Tote Gote 300. I has a 3hp Briggs with a 3/4" shaft. I have the original clutch, but it is pretty roached. Thanks
  7. 125ccCrazy

    Salsbuty driver tc for parts or to repair

    I have a salsbury tc driver from a wildcat 500, the back plate is broke but the rest looks good, good to fix with a new backer or use for parts to repair another one..... $15
  8. Ruppster81

    Comet 3/4 30 Series Driver Needed

    Anybody have a new or very good condition comet 30 series driver 3/4 bore? Not real picky but would like a black one? My little brother is stoked that we almost got his Fox FX200 done and this is the only part he needs.
  9. H

    Need a TC driver 3/4 shaft,Rupp Scrambler

    Hi, putting back together a Rupp Scrambler and need a belt and the part that mounts on the engine shaft, "converter" 3/4" shaft. does not have to be OME part.I have things to trade check my Ebay or call Dean 586-596-7746 Shelbt Twp. Michigan 48315. Regards, Dean
  10. X

    Dyna-torque 400 driver

    Anyone have a dyna-torque 400 series driver clutch? I obtained a speedway scorpion which has the driven clutch, but I need a driver. Thanks.
Top