hole

I'm trying to make a clutch brake work on my 5hp briggs, and need an engine cover with 4 holes around the crank. Thanks!

OK, I've got a Fantic Broncco that was previously owned by a complete freaking nimrod. The bike is Italian so all the original hardware is metric and the yuts drilled out a bunch of the holes for standard hardware! This included the swing arm mount holes on the frame. I'm swapping out the...

Wanted: Looking for a new style Shroud for a Tec HS50 WITHOUT the primer bulb or a primer bulb hole. Must be dent free and and in VERY good overall condition. Like this... EDIT: could also use the older style one with the older traditional recoil as long as the older style starter cup and...

i see some of the HIGH performance motors running a head gasket that blocks the oil return? whats the situation there? what gain is there in this?

Would 11/16 diameter drill bit be the right choice for drilling a hole for a 17mm diameter axle, or would 17mm be big enough. I am not sure if the hole in the brake assembly needs to be a little bigger than the axle itself. Thanks.

I hate the open hole that is left when you remove the knob kill switch from the shroud on a clone. I've tried various types of hole plugs from home depot like these without any luck. They don't fit snug in the hole due to the little teeth all around the circumference of the hole...

so im wondering what this hole is at the edge of the flange, it looks like it goes to the airscrew. im just wondering if this should be going to the intake of the engine. or if its closed and i shouldnt worry about it? im just concerned about getting dirt inside there and screwing up the carb...

anyone have a 5 whole valve cover for a new type greyhound clone, they want to sell or know where to get one..I got one from t & s but is was the older 4 hole type?? thanx John

so i got an old honda express and there is a tiny hole in the tank. my friend said if it was a little smaller i could plug it with pencil lead. any advice?

There are three holes where the jackshaft bearings mount...one for the swingarm...one big one for the jackshaft...and one for....??? scrub brake?:shrug:

ok i'm fresh fish here and i picked up a 05 manco thunderbird for my son's 9th b-day tomorrow and i had to rebuild the carb put on a new pull string and plug so i got everything done and i put gas in and it comes pissing out this tiny hole on the left side about middle of the carb. i thought i...

Is there any way to fix a wallowed out hole in a dune cycle axle? Can you weld it and redrill it, or drill it out for a bigger bolt? Any one got a spare axle for cheep? Thanks.

There is suppose to be a blizzard on the way so I decide its time to replace the bearings in my driven so I can play in the supposable coming snow. When i bought the Super Bronc it had a new driven installed by who i don't know. But they went the cheap way:doah:Thought it was odd i had play in a...

Honda 6.5 What is this hole and should it be here and why is it open?

where can i buy 3 hole bearing hangers anyone got 2 or 3 sets thay want to get rid of thanks shane