identification

I need some help in Identifying this ChainGuard Please

Good Morning OldMiniBikes. Since this section of the forum is so efficient at solving identification questions. What are your thoughts on this guy? The guy wants 50 bucks delivered.

Wondering what the heck this wheel originally came off of or if it is an aftermarket one? It came on a (pretty beat up) 1967 Taco 22 I got a while back. This was the back wheel and has a sprocket on the other side (that has had a lot of holes drilled into it (sprocket not wheel) from various...

Found this one today. Missing tank that would have made identification easier. Obvious engine replacement. Any ideas?

Hey guys, recently I picked up an old 1000w Sears generator, and I'm thinking about taking the motor off and doing a few modifications. I've done some research, and I'm pretty sure it's a Tecumseh HS motor (exhaust port facing the same direction as the output shaft). I want to do a few...

Can someone help me out with identifying this mini bike, it looks like a Sensation Minibike Chopper to me but all the Sensations that I have seen have a rear tire scrub brake and this one has a drum brake. Hopefully someone can help me with this one.

A friend of mine has this, wondering what it is. It looks pretty rough but didn't know if it was factory made or not. Any help is appreciated.

Non-Hemi Predator Valve Cover

I've had this sitting in the shed for years now. Curious about what it is. It was my dad's as well, I think mid 1960's. Sorry for the pic, but it's crammed behind a bunch of stuff at the moment. I was standing on a pile of lumber when I snapped the shot.

Tecumseh Engine ID (No Tin) ~ H35? Steel Lined, 2.5" Bore x 1.85 Stroke ~What is It? Just taking a look at these two Tecumseh engines I picked up at a swap meet a few weeks ago. The one on the left didn't come with any tin and had been repainted and played around with some so I took the...

Bought this yesterday also. Unsure of make model year. Any help would be appreciated. Thanks in advance.

just wanted to make sure that a genuine gx160 would actually have that stamped on the block... where if the block is stamped gx120... its obviously a gx120 with a gx160 recoil assembly on it? have a motor sitting, was going to put it up for sale and just fired it up for the first time (since...

I need help identifying a Briggs & Stratton Engine. The numbers on the fan shroud are as follows: 90402 CS15-01 7210191 SN795896 I believe this is a 1972 8 HP Briggs & Stratton. Is that correct? Any advice and/or tip will be helpful. Thank you in advance.

Hi everyone, new here. Firstly i don't have a minibike but i do have a Tecumseh engine that i am rebuilding, i have done heaps of searching trying to identify it so i know what parts to order but have come up with no luck and have ended up here. Hopefully someone can point me in the right...

I don't think these are very old but wasn't sure it they're American built or not. Any thoughts?

Hi, I'm new to the forum. Can anyone identify the two mini bikes in the photo ? Mine was the one on the left, the photo was taken around 1968 or so.

What is it? Mark

So yea, I'm hooked. I started messing with some of the doodlebugs and other new bikes to get the basics down and now I want to start collecting vintage. Id like to first apologize if I'm breaking any rules about where to post and what content. I know many of you are sick of the same questions...

I know I've seen pics of this bike before but can't find them now , any help with make and model greatly appreciated . Thanks

I'm new to this site, this is my first thread posted. Hello, please help me i.d. this bike. I've not seen a picture of it on the internet. I want to fix it up. Thanks much for any help. Another Ratman.