Original throttle linkage from a Tecumseh hs40 up for grabs. Took off just recently to replace with something different. First 1$ plus shipping from raleigh nc. paypal works best
I have a couple of old Briggs engines I am trying to use on a couple of minibikes. They were torn down when I obtained them, and as I have them back together, I can't figure out how to hook up the governor spring (where to connect it), and how to rig the throttle cable to the throttle control...
Hello there guys! New to mini bikes and am in need of some help.
Bike: Manco Tbird 3.5 tecumseh
After creeping on here for awhile i think all im missing is the linkage(part #37735?) to connect the governor to the throttle valve. So without that part the governor arm stays pulled towards the...
Hello, I just scored a 3-4 year old doodle bug from my neighbor, his kids only put an hour on it and then lost interest. Upon inspection when I twist the throttle wide open every thing looks good but when I release the twist grip the throttle (at the carb) stays in the WOT position. No coming...
Finally finish assembled my latest bike today. The throttle linkage took some figuring out. It's a 1969 3hp copper briggs with the updraft carb. Not missing any parts for the governor. I set it up so that the square rod gets pulled down by the twist throttle' s cable. That looks like it should...
Hello all.
I am in need of the top plate and stock throttle linkage for a Honda GX160/200 motor. I need the plate, throttle arm, the washer, spring, rod, and nut. Dont need any of the governor linkage or arms.
PM me what you have.
Hey Fellas, I'm hoping someone has this L-shaped piece, and the spring that goes with it laying around. :thumbsup:
I believe it comes with a spring that mounts with it as shown in the exploded parts diagram.
I've also seen them like this.
So I just picked up what I believe is a home built MB with a 65 4HP Briggs. Cleaned the carb and gas tank and it fired right up but won't run with a load on it. my thought it the throttle config is wrong I have looked and looked and have not found anything that is the same config as what I...
I have a H50 and the standard linkage I bought from OldMiniBikes is clearly not the correct one. I purchased part number 730136A.
I am putting back together a Stellar - George Barris Super Stocker and it did not have the correct engine. I purchased the H50 and what I thought was the correct linkage...
How do you guys have your throttle pedal linkages set up? My cable keeps pulling out of the rod tha connects to the pedal.
Pictures would be helpful
Thanks matt
As you guys know I’m pretty new to all this. I have upgraded my engine took out the governor. Well now the throttle linkage is driving me crazy. Can you guys post some pictures of your custom throttle linkage with out the governor
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.