Anybody on here who can do all the machine work for this? Or can somebody point me in the right direction for it? I'm looking to get a resleeved block and milled piston.
Hello I have just finish building my new engine, its a hemi bottom end with a 18cc honda head milled 50 thousands. I am concered about the pushrod length, will the stock non hemi pushrods work or do i need cut to fit pushrods? I have started this engine already and it seems ok but i would like...
I have a predator head that was done by Stoney Creek here in Michigan. The head has been ported ,polished and milled .065. This head flows very well and will give your predator all kinds of extra power. Looking for $65 shipped to lower 48.
Fits Briggs flathead 5hp
Professionally Milled appx .045". Relieved area for exhaust as well. It has not been used since the machine work was done.
Threads are perfect.
Asking $55 and that includes shipping anywhere in the lower 48.
xtrac carlisle 13x5x 6
knobbies nice condition.
And BRIGGS 5 HP head milled by machineshop $17.00 shipped
Im not using the big knobbied tire and the head worked nice until my chain popped and wedged in the cent clutch.
Took things a part and Im not putting back together becausee I got a...
I have a fresh Intek head milled .060. new animal valves, new dbl valve springs with locks and retainers, fully ported...never used
It's installed on this engine but has never been fired..
$100 obo $11 ship
I also have a very nice the billet jr flywheel and coil with 8mm wire for $75...
I took my head to my friend's house tonight and had him mill .055 off. It turned out pretty nice. I will polish the chamber one more time before installing. Can anyone advise whether or not I can use the original head gasket again? The engine has never had gas or oil in it before it was torn...
I have a 6.5 that I am going to build, I dropped the head off to get milled .065... My questions are, Will a flat top piston with the head milled be too much compression?? next question: which engine has teh flat top piston stock?? gxv160 mower engine or the gx160 horiz shaft eng??
I'll be...
I just bought these, but they didn't quite go with the look im going with on my build, but they are a killer set. For a 1" bar, Never installed, perfect condition. $45 shipped
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.