noram

I have a decent used North American belt clutch for sale. 3/4" bore, fits A or B size belts. Used on dirt compactors. That's what it was on when I got it. I never did test it before removing it from the engine, but everything looks like it's in good working order. Asking $65 plus shipping...

Brand new 1" clutch and brake band. $90 shipped. PayPal preferred, USPS money order of cash works also.

Cleaning out the garage and found this pair of vintage clutches. NORAM (North American Clutch Co.) has steel shoes, 3/4" bore, 10T for #41 Chain. ALLSTATE has composite shoes, bronze bushing... 5/8 bore, 10T for #35 chain. There were bikes (Sears?) that used the clutches as OEM equipment but...

I was wondering if the noram cheetah clutch has a horsepower range/limit. Hoping for close to 20 hp with setup I am running. I am not sure if the 2 disk is enough or do I need a 3 disk. Any info is appreciated.

Used clutch for 35 chain 3/4 shaft. 20$ plus shipping from 10509. Paypal.

This is a loncin 420cc generator motor I used to get my Warrior past 60mph. Between a Ninja and a free 270cc engine, I've decided to take my project back to reasonable speeds, so this is now available. There's about 100 miles on the engine - I never rode it as much as I meant to. It's a...

A couple years back I bought a new Noram Titam clutch for a clone engine. Never got to install it and have since reinstalled the Briggs 5hp engine that came with the bike. My question is.... What advantages would I have with the new Titan clutch (12t) over a new Max Torque (12t) on the same...

I bought a lot of noram clutches and have a question. I got a 13, 14 & 17 tooth basket that have needle bearings and a hub to fit those. I also got a 12 tooth basket with a cooper bushing and another hub, but the hub doesn't extend into the bushing. The hub is keyed and is 3/4" but the basket...

We now carry Noram clutches and accessories! We are starting out with just the 3/4" shaft but will have 1" on our website next week. We have the interchangeable springs and shoes as well. Check it out here: Noram Clutches

Never used, in the box... 17 tooth. $79.00 shipped {lower 48} via U.S.P.S.. PayPal preferred. Ck. or M/O is fine too. No trades.

up for sale is two 6.5 clone carbs. one is from a champion i think and the other one is off of a harbor freight clone $15 each and a Noram 15 tooth Clutch 35 pitch. has a noticeably higher stall than stock. $25. Located in so-cal. Payments in cash or US POSTAL money order.

In great shape - $65 shipped from 49235.

barely used noram cheetah 2 disc 6 spring 14t 15t 16t 90$ shipped or looking for a shoe styled clutch like a max torque drag skin trade

I'm looking for a racing clutch for my predator clone max rpm @ 8,000 13" rear wheel 59 sprocket mikuni 22m .065" milled copper gasket 27mm intake 25mm exhaust billet rod, flywheel 8 degree timing black mamba cam billet lifters, moly push rods, 1.3 rockers Need some suggestions...

This clutch is on that B&S 8hp engine I bought this week. What make is this clutch? Neck thinks this clutch on it is a Noram. I can remove it two ways. One way will destroy it. The other way. I can make a puller. Just to remove this clutch. I have soaked it for two days with...

I have 4 noram star 1" bore clutch drums with bearings for sale. they are either new or like new with very little use. the teeth are in excellent condition on the used ones. there are two 17 tooth drums, an 18 tooth drum and a 21 tooth drum. new these sell for around $100 each. asking $150...

3/4" Noram Cheetah clutch comes with all the stuf it does when new, i broke the clutch in and used it at the ubly dragway minibike event on sunday and thats it maybe 10 runs on it. 13, 14, and 15 tooth drivers included 13t is on it now. $130 shipped paypal +4%

I have a Noram GE for sale. I have some black springs with it, some brown springs with it, and some heavier red springs with it. Clutch works fine. Pics in a few. $30 + shipping. This is a good clutch for someone with a high hp engine but would like to retain the ease of use and...

Hey guys, I have a noram clutch that I have what I believe off the top of my head is an 18 tooth, I need a 13 or a 14 gear if anyone has one avail. I have some greased lightning gears to trade if anyones interested Thanks Joe

Here's a good condition noram clutch. Don't know much about it I used it on a 5hp briggs but it kept engaging and disengaging so I assume its for a higher reving motor. 12 tooth #35 chain, 3/4 bore. U.S. POSTAL MONEY ORDER ONLY!!! $30 shipped.:thumbsup: The two speed isn't for sale.