installed height is too high correct? so if you cut the spring pockets you can get them to sit lower? using nr 274 lift 260 duration cam with locks and retainers with lash caps
Honda/Clone valve retainers to use 26lbs springs on stock valves. 20$ plus shipping. About 1 hrs run time on 18lbs springs. Paypal. Shipping from 10509 should be only couple bucks to anywhere.
I have two retainers off some shocks that were kaput. I had them chromed with the rest of the stuff I recently had done for the CAT. I wouldn't call them perfect, but they are nice and shiny on the business side.
Asking $25 OBO shipped. Paypal preferred.
I have an extra 165 clone I am messing with, can I use I use lightweight aluminum retainers and split keepers with stock valves or do I have to use stainless valves?
this may be a dumb question, but I'm wondering if you use lightweight retainers and keepers on stock valves do you need to use lash caps? can you use the stock ones? or do the retainers and keepers only work on ss valves? thanks this is my first engine build.
Billet aluminum clutch retainers...
6061 T-6...
Round available any OD up to 1.375"...
Hex available in 1.250" and 1.375" OD...
Satin or polished...$5 each w/mounting screw plus $3.70 shipping (will combine for quantity)
Bronze retainers available in round only, any OD up to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.